Changjian Loader Tire Maintenance Tips — Extend Lifespan, Improve Efficiency

Loader tires are a critical component of the equipment, directly impacting operational efficiency, safety, and operating costs. Changjian loaders are renowned for their reliability and durability, but proper tire usage and maintenance are equally vital. Below are tire maintenance tips for Changjian loaders to help you extend tire life and reduce maintenance costs. I. Daily Inspection and Maintenance 1. Tire Pressure Management Regularly check tire pressure: Both over-inflation and under-inflation can affect tire life and operational safety. Over-inflation: Reduces the tire's contact patch, increasing the risk of slipping and accelerating wear in the center of the tread. Under-inflation: Increases tire deformation, which can lead to sidewall cracking, overheating, and even blowouts. Adjust tire pressure based on working conditions: On soft ground (e.g., sand, mud): Slightly reduce tire pressure to increase traction. On hard surfaces (e.g., concrete, gravel roads): Maintain standard tire pressure to minimize wear. 2. Tire Wear Inspection Check tread depth: If tread wear exceeds 50%, it is recommended to replace the tire, as this can otherwise compromise traction and braking performance. If uneven wear is detected (severe wear on the inner or outer side), it may indicate issues with the steering or suspension system, requiring timely repair. Inspect tread damage: Check for cuts, punctures, bulges, etc. If found, repair or replace the tire promptly to avoid the risk of blowouts. II. Proper Usage Practices 1. Avoid Sudden Acceleration and Hard Braking Frequent sudden acceleration and hard braking accelerate tire wear. Operate smoothly to reduce tire slipping. 2. Minimize Pivot Turns in Place Turning the steering wheel while stationary increases friction between the tire and the ground, leading to abnormal wear. Adjust the direction while the vehicle is in motion whenever possible. 3. Load Properly and Avoid Overloading Overloading significantly increases tire stress and shortens service life. Always operate within the rated load capacity of the Changjian loader. 4. Choose the Appropriate Tire Type Standard tires: Suitable for general construction sites and highway transport. Deep-tread tires: Suitable for soft, muddy surfaces to enhance traction. Solid tires: Suitable for environments with gravel or sharp objects, offering strong puncture resistance. III. Storage and Seasonal Maintenance 1. Precautions for Long-Term Parking If the loader is to be out of service for an extended period, elevate the tires to avoid deformation from sustained point pressure. Avoid direct sunlight exposure to prevent rubber aging. Regularly check tire pressure to prevent damage from prolonged under-inflation. 2. Winter and Summer Maintenance Winter: Low temperatures can harden the rubber and cause tire pressure to drop; add air as needed. Summer: High temperatures can cause tire pressure to rise; avoid prolonged high-speed operation to prevent overheating and blowouts. IV. Tire Replacement and Repair 1. When Should Tires Be Replaced? Tread depth is below 3mm (or worn to the wear indicator). Severe cracks or bulges are present on the sidewall. The tire has been repaired too many times (generally, more than 3 repairs means it should no longer be used). 2. Repair Precautions Minor punctures (<6mm) can be professionally repaired, but sidewall damage is not recommended for repair and should be replaced directly. After repair, perform a dynamic balance test to avoid vibration at high speeds. V. Summary Proper maintenance of Changjian loader tires not only extends their service life but also enhances operational safety and cost-effectiveness. Key points include: ✅ Regularly check tire pressure and wear conditions ✅ Drive correctly, avoiding hard braking and sharp turns ✅ Select the right tire type based on working conditions ✅ Provide proper protection during long-term parking ✅ Replace or repair damaged tires promptly By following these maintenance tips, your Changjian loader tires will be more durable, and your operational efficiency will be higher!